smartctl 6.5 2016-05-07 r4318 [x86_64-linux-4.11.3-unRAID] (local build) Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: ST2000DL004 HD204UI Serial Number: S2H7J9GC309080 LU WWN Device Id: 5 0004cf 20706d400 Firmware Version: 1AQ10001 User Capacity: 2,000,398,934,016 bytes [2.00 TB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Form Factor: 3.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Wed Jun 14 21:40:17 2017 PDT SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (20040) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 334) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 100 100 051 Pre-fail Always - 19 2 Throughput_Performance 0x0026 252 252 000 Old_age Always - 0 3 Spin_Up_Time 0x0023 067 067 025 Pre-fail Always - 10069 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 558 5 Reallocated_Sector_Ct 0x0033 252 252 010 Pre-fail Always - 0 7 Seek_Error_Rate 0x002e 252 252 051 Old_age Always - 0 8 Seek_Time_Performance 0x0024 252 252 015 Old_age Offline - 0 9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 1803 10 Spin_Retry_Count 0x0032 252 252 051 Old_age Always - 0 11 Calibration_Retry_Count 0x0032 252 252 000 Old_age Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 225 181 Program_Fail_Cnt_Total 0x0022 100 100 000 Old_age Always - 7919385 191 G-Sense_Error_Rate 0x0022 100 100 000 Old_age Always - 254 192 Power-Off_Retract_Count 0x0022 252 252 000 Old_age Always - 0 194 Temperature_Celsius 0x0002 064 062 000 Old_age Always - 26 (Min/Max 15/41) 195 Hardware_ECC_Recovered 0x003a 100 100 000 Old_age Always - 0 196 Reallocated_Event_Count 0x0032 252 252 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 252 252 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0030 252 252 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0036 099 099 000 Old_age Always - 674 200 Multi_Zone_Error_Rate 0x002a 100 100 000 Old_age Always - 3 223 Load_Retry_Count 0x0032 252 252 000 Old_age Always - 0 225 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 596 SMART Error Log Version: 1 ATA Error Count: 8 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 8 occurred at disk power-on lifetime: 1551 hours (64 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 bf 00 c6 f2 ef Error: ICRC, ABRT 191 sectors at LBA = 0x0ff2c600 = 267568640 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 d8 e7 c6 f2 ef 08 00:00:04.708 READ DMA c8 00 08 df c6 f2 ef 08 00:00:04.708 READ DMA 25 00 c8 17 c4 f2 e0 08 00:00:04.708 READ DMA EXT c8 00 e8 2f c3 f2 ef 08 00:00:04.708 READ DMA c8 00 08 27 c3 f2 ef 08 00:00:04.708 READ DMA Error 7 occurred at disk power-on lifetime: 1551 hours (64 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 4f c0 1d 71 ec Error: ICRC, ABRT 79 sectors at LBA = 0x0c711dc0 = 208739776 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 98 77 1d 71 ec 08 00:00:04.047 READ DMA c8 00 d0 a7 1c 71 ec 08 00:00:04.047 READ DMA c8 00 20 87 1c 71 ec 08 00:00:04.047 READ DMA 25 00 58 2f 1b 71 e0 08 00:00:04.047 READ DMA EXT c8 00 30 ff 1a 71 ec 08 00:00:04.047 READ DMA Error 6 occurred at disk power-on lifetime: 1551 hours (64 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 a7 40 73 d7 ea Error: ICRC, ABRT 167 sectors at LBA = 0x0ad77340 = 181891904 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 a8 3f 73 d7 ea 08 00:00:03.723 READ DMA 25 00 48 f7 6f d7 e0 08 00:00:03.723 READ DMA EXT c8 00 a8 4f 6f d7 ea 08 00:00:03.723 READ DMA 25 00 00 4f 6b d7 e0 08 00:00:03.723 READ DMA EXT c8 00 10 3f 6b d7 ea 08 00:00:03.723 READ DMA Error 5 occurred at disk power-on lifetime: 1551 hours (64 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 77 00 35 e0 e6 Error: ICRC, ABRT 119 sectors at LBA = 0x06e03500 = 115356928 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 b0 c7 35 e0 e6 08 00:00:02.957 READ DMA 25 00 00 c7 31 e0 e0 08 00:00:02.957 READ DMA EXT c8 00 10 b7 31 e0 e6 08 00:00:02.957 READ DMA 25 00 f0 c7 2d e0 e0 08 00:00:02.957 READ DMA EXT c8 00 10 b7 2d e0 e6 08 00:00:02.957 READ DMA Error 4 occurred at disk power-on lifetime: 1551 hours (64 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 27 80 3f 74 e5 Error: ICRC, ABRT 39 sectors at LBA = 0x05743f80 = 91504512 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 30 77 3f 74 e5 08 00:00:02.684 READ DMA 25 00 f0 87 3b 74 e0 08 00:00:02.684 READ DMA EXT c8 00 10 77 3b 74 e5 08 00:00:02.684 READ DMA 25 00 f0 87 37 74 e0 08 00:00:02.684 READ DMA EXT c8 00 10 77 37 74 e5 08 00:00:02.684 READ DMA SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1803 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Completed [00% left] (0-65535) 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.